 |
Step One – Measure the circumference
of the object that you wish to wrap. |
 |
Step Two – Measure length of
Bumperwrapä to match the circumference of
the object, and cut to the determined length. A sharp
utility knife or
heavy-duty scissors will work well for cutting Bumperwrapä.
For best
results, use a metal framing square or similar tool to
ensure a square cut.
Check the length by wrapping the cut piece tight around
the object,
leaving ½” gap for the fasteners. When wrapping
the same size object in
several applications, complete first installation to check
for a good fit. |
 |
Step Three - Feed the fasteners through
Bumperwrapä. Four straps or cable
ties are recommended for most applications. On small poles,
more
fasteners may be required. For installations of 48”
or less, use heavyduty
cable ties available from your distributor. For longer
installations use
½” pallet banding (plastic
strap and buckles are also available from your
distributor)
(Silicone spray can be used to aid
in sliding the attachment banding into Bumperwrapä) |
 |
Step Four – Apply the material
at the optimum height for vehicle protection
and visibility. Multiple layers of 12” Bumperwrapä
can be applied to
achieve 24” or more of protection. |
